Anti-corrosion storage tankWhen the inlet and outlet flow rates are large during use, exhaust holes with corresponding flow rates should be installed. When changing the liquid contained, you should know whether the liquid contained in the anti-corrosion storage tank is allowed. If necessary, you can check the company's website or contact the company's technical department.Anti-corrosion storage tankIf there are joints or flange-connected pipes at the lower part, they should be perpendicular to the barrel wall. It is best to use soft connections to avoid uneven expansion of the upper and lower sides of the barrel wall after being filled with liquid, causing damage to the joint connections and resulting in leakage. In severe cases, the joints and the barrel body may be damaged. When the liquid inlet is higher than the tank bottom, the liquid inlet should be bent toward the wall of the anti-corrosion storage tank to allow the incoming liquid to fall along the tank wall to reduce the impact on the bottom. The storage pressure of anti-corrosion storage tanks is relatively large, so when connecting with other flanges, attention should be paid to strengthening them. Ordinary flanges and anti-corrosion storage tanks are generally tightened when leaving the factory, which may cause loosening during transportation, loading and unloading. Users should check the sealing performance of the rotomolded storage tank before use, and add liquid to observe whether there is leakage. Rotational molded storage tanks containing chemical liquids are best tested for leaks with water to prevent losses.